Speed Laces Instructions

Hidden Mode

1. Thread laces per normal until they are one hole short of the desired finishing holes. Then thread through the last hole from the outside so that the lace ends finish on the inside of the shoe.
2. Thread the lace through the hole in the anchor that is furthest from the end with the teeth. Then thread back through the other hole.
3. Wrap around the teeth and lock into place with the clip at the other end.
4. Trim the excess lace so that approximately 1-1.5 centimetres remains hanging out of the clip.
5. To ensure that the lace ends do not fray, an adult can either paint a small amount of nail polish on the ends or melt them briefly with a lighter.

 

 Visible Mode

1. Thread laces per normal until they reach the desired finishing holes. The laces should exit the last holes on the outside of the shoe.
2. Thread the lace through the hole in the anchor that is furthest from the end with the teeth. Then weave through the other hole.
3. Wrap around the teeth and lock into place with the clip at the other end.
4. Trim the excess lace so that approximately 1.5 centimetres remains hanging out of the clip.
5. To ensure that the lace ends do not fray, an adult can either paint a small amount of nail polish on the ends or melt them briefly with a lighter.
6. Thread the lace through the back of the lock end and snap shut.